Scott Session Fly Rod

Product detailed description

Scott team designed and crafted a series of rods to help you get the most from your time on the water-the most success, and the most enjoyment.
Scott Session rods are high-performance hand-crafted fly rods that blend some of our most acclaimed design approaches with our latest materials and technologies.
This combination creates rods that bring together high line speed and exceptional loop control with a light and lively feel in the hand. These traits have become known as Scott’s signature fast with feel action.
It gives the rods a wide bandwidth of performance for fishing at a range of distances, and for using a variety of flies and techniques with the same rod.
Most of all it means having fun on the water and enjoying the rod in your hand.

Assembly and Disassembly

Grasp the opposing rod sections close to the ferrule without touching the guides and firmly push them together with a downward twisting motion until the sections are aligned and tightly seated. Disassemble by pulling and twisting apart with your hands close to each ferrule but not touching the guides. Internal ferrules should have a 1/8-1/2 inch gap between sections to allow for proper flex and wear.

Effects Of Water On Your Rod

Your rod is made to perform on the water and is designed to get wet. It is not made to withstand storage while wet. Always completely dry your rod before storing it. Otherwise, you will have mildew, mold, damage to the finish, and/or corrosion on your rod next time you take it out of its case. Always rinse your rod with freshwater and dry thoroughly if you’ve used it in salt water.

Preventing Rod Breakage

Avoid hitting your rod with hard or sharp objects like tree branches, weighted flies, split shot, or rocks. This can either break the rod or cause damage that will lead to breakage. When fishing sinking lines, casting in windy conditions or using roll casts and spey style casts, periodically check the sections of your rod to make sure they are still assembled tightly and properly aligned. If the sections are not fit tightly, it’s possible to break the rod during a cast or while fighting a fish. When fighting and landing fish, avoid rod angles greater than 45-50 degrees. Never lift a fish so that the butt of the rod is pointing at the fish (high sticking) or use your hand to lift fish from the middle of the rod. To dislodge a snagged fly, point the rod directly at the snag and pull back on the line until the fly dislodges or the tippet breaks. It is much less expensive to lose a fly than to break a high performance hand crafted rod. When stringing your rod, fold the end of the fly line in two and pull it and the leader straight through the guides without bending the rod. The tip of your rod is the most vulnerable section as it is fine in diameter, light weight and usually nine or more feet away from you. Most fly rods are broken in car doors, windows, ceiling fans, vacuum cleaners, pets, or just about anything other than actual fishing. Extra awareness when moving with your rod assembled or setting it down will extend its life. Please take good care of your rod, and it will take good care of you.